Item # Y11206
Looking for a car seat that is easy to install? Did you know if you have a seat that is easier to install there is less of a chance that it will be installed incorrectly? The True Fit Convertible Car Seats have all been awarded high "ease of use" ratings from the National Highway Transportation Administration, NHTSA for short. What does that mean? That after reviewing our seats, our labels, and our instructions it was determined our seats were Easy To Use! The True Fit Rebound (model C670) was awarded Five Stars in both the rear and forward facing modes, the maximum awarded by NHTSA, and our True Fit (model C630) was awarded Four Stars in both the rear- and forward-facing positions. And new to the True Fit of highest-rated car seats is the True Fit Recline (model C650).
Why buy the True Fit convertible seat? Did you know that you can use our seat from 5 to 65 lbs, and during the entire time of use your child will be secured in a 5-point harness. And most Safety Advocates recommend keeping your child in a harness as long as possible! Advocates also recommend keeping your little one rear-facing for as long as possible. We have a removable headrest that really is easy to remove. One finger lifts the release and you are able to pull the headrest off until you need it, usually up to 22lbs. As your infant starts to grow, simply add the headrest back on and you are good to go in the rear-facing position up to 35lbs. And when your infant is ready to watch you drive (at 35 lbs or so) simply make sure that headrest is in place and turn your seat around. And remember, when your child does move to a forward facing position, (around 35 lbs), your child will still be using the 5-point harness.
The C650 model features smaller bottom rails and a flip foot on the bottom---flip it forward for rear-facing installation and flip it back with your move to the forward-facing installation. This seat is fully-lined with EPP foam and has deep side wings that really surround your child.
We have added a center angle indicator in the front of our seat for use when installing in the rear-facing position. This new easy-to-read indicator will help you determine if you have installed your seat correctly. For your infant, it will indicate the advocate-recommended 45-degree angle for installation (without our headrest), and as you keep it rear-facing to 35lbs (with the headrest) you can check for the recommended 35 degree angle for installation.
We have also moved both side LATCH attachments so they are easy to access when you are installing your seat and easy to secure when you remove the seat from your vehicle.